Table of Contents
Advertisement
LOADER REMOVAL
AND INSTALLATION
Storage
End of Season:
If loader is to be dismounted from the tractor
during storage, make sure the parking area is
on hard, level ground. Cap all hydraulic hoses
to prevent contamination.
Store loader in a dry, sheltered
area if
possible.
Thoroughly
clean
the
loader
of all
accumulated dirt and grease.
Completely lubricate the loader as specified
in "Lubrication" section of this manual.
Using an oil soaked cloth, lubricate
all
hydraulic cylinder rods to protect them from
rust and corrosion.
Repaint any areas where paint is worn or
damaged.
Wear areas on bucket should be coated with
grease to prevent rust or corrosion.
Replace any Safety or Warning Labels that
are not readable due to wear or damage.
Replace any damaged or worn parts.
A -
m
To Prevent Accidents do
not allow children to play on or around the
tractor or loader.
Remove sub frame if required for other
attachments.
See
sub
frame
installation/removal section. .
Beginning of
SeaSOn
Thoroughly
clean
the
loader
of all
accumulated dirt and grease.
If removed from tractor for storage, remount
loader per procedure in this manual.
Completely
lubricate
the loader
per
"Lubrication" section of manual. Make sure all
fittings are taking grease properly.
Clean with solvent any exposed surfaces
which had been coated with grease: Wipe dry
with a clean cloth, then lubricate with an
oil-soaked cloth.
Tighten any bolts that have been loosened
and make sure all pins and retainers are in
place.
Start tractor and operate loader to make sure
it is operating property and all the hoses are
properly connected.
Check hydraulic fluid level in tractor and fill
as required. Use oil recommended in tractor
owner's manual.
Make sure hydraulic hoses, lines and fittings
are in good shape and not leaking. Replace
or repair as required.
Review safety precautions and operation
sections of this manual.
33
Advertisement
Table of Contents
