Honda FL6555 Operator's Manual page 36

LOADER REMOVAL AND INSTALLATION
Loader Installation
Install sub frame if removed. See sub frame
installation section.
Carefully drive the tractor into the loader to a
position where the hydraulic hoses can be
connected to the tractor control valve.
Note: The tractor front mount should be
aligned with the loader front crosstube.
Shut the tractor OFF and connect the
hydraulic couplings to the tractor.
Start the tractor and drive ahead slowly to
position the loader front crosstube into the
tractor front mount.
Note: Activate the bucket cylinders and lift
cylinders as required to align the loader
crosstube/front mount and tractor front
mount.
Shift the loader control valve into the 'Float"
position
With the loader assembly secure in the tractor
front mount, extend the bucket cylinders to
lower the loader assembly onto the rear
mount.
Shut the tractor OFF and secure the loader
assembly
hinges.
Start the tractor, raise. the loader off the
ground and position bucket cutting edge
vertical to ground.
Lower loader to position bucket cutting edge
on ground and shut tractor off.
Remove the parking leg and place in storage
position.
Lubricate all loader pivot pins.
34