Test/Service - Life Pulse Test - Life Fitness LC9500R Service Manual

Lifecycle Recumbent Bikes LC95R, LC91R, LC85R, R9, R7, 95Ri, 93Ri, 90R, and 95Re

TEST/SERVICE - LIFE PULSE TEST

C - O G 9 9
Upon initial entry to this test, a heart-shaped image will be displayed in the profile window along with two messages
in the message center when the user has both hands on the LifePulse sensors. The first message indicates the
LifePulse software version number. The second is the configuration of the LifePulse communication system, which
is either ON or OFF. This setting enables external communications for LifePulse development only and should be
left OFF. Following these messages, the display will change to a mode to display diagnostic information as
described below, and the LifePulse system will be ready to be manually tested.
When both hands are detected on the sensors, the letters 'L' and 'R' will be displayed in the profile window along
with the heart-shaped image.
Two timers will begin counting from the time both the left and right hands on condition occurs. The first timer,
located on the upper console message center display, will stop counting when LifePulse computes and displays an
initial peak detected heart rate reading. The second timer, located on the lower console display window, will
continue counting until LifePulse can reliably display the users heart rate. These timer readings are used for
reference only.
The gain value of the heart rate signal is shown following the 'G' in the message display window. The value ranges
from 0 to 99. A gain value of 99 is considered to be high and undesirable. A gain value of 0 is considered to be low
and also undesirable. Gain values of between 15 and 40 are considered normal depending upon whether the user
is exercising or standing still during this test.
Press the ENTER key to advance to the next diagnostic state. Press the CLEAR key to the previous diagnostic
state, or repeated pressing to exit diagnostics.
15