Lifecycle Recumbent Bikes LC95R, LC91R, LC85R, R9, R7, 95Ri, 93Ri, 90R, and 95Re
How To... Replace the Intermediate Pulley Shaft and Bearings
Special Service Tools: Bearing Service Tool Kit – Part Number: BearingToolKit
1. Remove the side shrouds. See "How To..." in this section.
2.
Snap
Ring
Main
Drive
Belt
Remove the alternator and main drive belt.
See "How To..." in this section.
3. Remove the clutch assembly. See "How
To..." in this section.
4. Assemble 2-jaw puller to the bike frame at
the intermediate pulley shaft as shown.
Note: Some bearing spacer may or may not
have shoulder on spacer.
Spacer w/o Shoulder
Clutch
Assembly
Washers
Intermediate
Bearing
Spacer w/Shoulder
Spacer
Intermediate
Pulley
Intermediate
Pulley/Shaft
Assembly
Bearings
SETTING UP 2-JAW PULLER
11
Intermediate
Bearing
Alternator
Belt
Spacer
Use Standard
2-Jaw Puller