Table of Contents
Advertisement
21. Install two figure-8 hook loops on the
connecting sleeve using
slotted truss head screws (inserted from inside
the connecting sleeve),
washers and two 5/16 inch lock nuts.
Position the figure-8 hook loops so they face
the opening of the connector sleeve.
Tighten the nuts securely.
x
22. Attach three locking straps to the discharge
chute assembly.
a.)
Attach one rubber strap to the middle chute
by inserting a 5/16 x 1 inch pan-head screw
from inside the chute. Thread the
(Phillips)
rubber strap onto the screw ("S" hook
toward the flex hose): Secure with the 511 6
flat washer and the 511 6 lock nut.
MIDDLE CHUTE
inch
FLAT WASHER
Inch
RUBBER STRAP
two
two
5/16 inch flat
X
5/16
1 inch PHILLIPS
PAN-HEAD SCREW
Install tyo rubber straps on the flex hose by
b.)
inserting two 5/16 x 1 inch pan-head screws
(Phillips) with
two
from inside the flex hose. Thread the rubber
straps onto the screws
from the flex hose). Secure with
washers and the 5/16 lock nuts.
23. Install the middle chute assembly by inserting
the flexible end into the connecting sleeve and
placing the other end on the lower chute.
Position the middle chute assembly so the
window faces the driver's seat.
Attach the two upper
on the connecting sleeve.
Attach the lower hook to the hook loop on the
lower chute.
CONNECTING
ASSEMBLY
5/16 inch fender washers
hooks away
two
5/16 flat
RUBBER STRAP (2)
NDER WASHER (2)
hooks
to the hook loops
MIDDLE CHUTE
Page
7
Advertisement
Table of Contents
