Hitch Assembly - Honda BC4050 Operator's Manual

Thread the dump cloth rod through the sleeve
14.
in the rear edge of the dump cloth.
Position the dump cloth with the connecting
sleeve cut-out at the right side of the cart.
Insert the ends of the rod through the holes in
the rear corners of the
Secure each end of the rod by installing a circle
clip outside the cart bed.
DUMP CLOTH
CIRCLE CUP
15. Spread out the dump cloth in the cart box, and
hook the four plastic clips onto the support
tube.
c a r t .
DUMP CLOTH ROD
16. Install a rubber strap and hooks on the washer
at the center of the cover frame rod. The open
end of the lower hook must face the cart bed.
Secure the upper hook to the frame rod by
closing the hook loop with pliers.
To hold the cover closed, hook the lower end to
the cart bed as shown.
Hitch Assembly
17. Install the hitch bracket on the rear of the
tractor, using one 1/2 x 1 inch hex bolt, one
inch lock washer, one
four 8 x 20 mm hex bolts and four 8 mm lock
washers.
Tighten the nuts and
HITCH BRACKET
\
LOCK WASHER
ASSEMBL Y
RUBBER ROD WASHER
inch nut,
1/2
bolts
securely.
x
1 inch HEX BOLT
HEX BOLT
Page
5