Using The Bios Recovery Header Cn34; Procedure 1: Reboot With Recovery.cap File - Cisco UCS C24 Installation And Service Manual

Service Headers and Jumpers

Using the BIOS Recovery Header CN34

Depending on which stage the BIOS becomes corrupted, you might see different behavior.
•
•
As indicated by the message shown above, there are two procedures for recovering the BIOS. Try
Note
procedure 1 first, then if that does not recover the BIOS, use procedure 2.
The server must have CIMC version 1.4(6) or later to use these procedures.
Note

Procedure 1: Reboot With recovery.cap File

Download the BIOS update package and extract it to a temporary location.
Step 1
Copy the contents of the extracted
Step 2
recovery
Note
Insert the USB thumb drive into a USB port on the server.
Step 3
Reboot the server.
Step 4
Step 5 Return the server to main power mode by pressing the Power button on the front panel.
The server boots with the updated BIOS boot block. When the BIOS detects a valid
on the USB thumb drive, it displays this message:
Found a valid recovery file...Transferring to CIMC
System would flash the BIOS image now...
System would restart with recovered image after a few seconds...
Wait for server to complete the BIOS update, then remove the USB thumb drive from the server.
Step 6
Cisco UCS C24 Server Installation and Service Guide
2-16
If the BIOS BootBlock is corrupted, you might see the system get stuck on the following message:
Initializing and configuring memory/hardware
If it is a non-BootBlock corruption, the following message is displayed:
****BIOS FLASH IMAGE CORRUPTED****
Flash a valid BIOS capsule file using CIMC WebGUI or CLI interface.
IF CIMC INTERFACE IS NOT AVAILABLE, FOLLOW THE STEPS MENTIONED BELOW.
1. Connect the USB stick with recovery.cap file in root folder.
2. Reset the host.
IF THESE STEPS DO NOT RECOVER THE BIOS
1. Power off the system.
2. Mount recovery jumper.
3. Connect the USB stick with recovery.cap file in root folder.
4. Power on the system.
Wait for a few seconds if already plugged in the USB stick.
REFER TO SYSTEM MANUAL FOR ANY ISSUES.
folder contains the
recovery.cap
The file must be in the root directory of the USB thumb drive. Do not rename this
recovery.cap
file. The USB thumb drive must be formatted with either FAT16 or FAT32 file systems.
folder to the root directory a USB thumb drive. The
recovery
file that is required in this procedure.
Chapter 2 Installing the Server
file
recovery.cap
OL-26647-01