Life Fitness 8500 Service Manual page 95

Total body cross-trainers with rear drive system
Hide thumbs Also See for 8500:
Table of Contents

Advertisement

Step 10
®
Locate the POLAR
ISOLATOR (#15) over the POLAR RECEIVER.
Remove the POLAR RECEIVER JACK (G) located at
the front of the MONOCOLUMN (F) near the PIVOT
SHAFT (H) from the tape and plug the POLAR
RECEIVER into the POLAR RECEIVER JACK.
Step 11
Locate the front and back MONOCOLUMN COVERS
(#5 & #6). With the wire positioned on top, carefully
insert the POLAR RECEIVER (#16) between the
vertical ribs located inside the BACK MONOCOLUMN
COVER (#6).
Place the BACK MONOCOLUMN COVER (#6) over
the PIVOT SHAFT (H) at the top of the
MONOCOLUMN (F).
NOTE: THE POLAR RECEIVER WIRE MUST BE POSITIONED ON TOP WHEN INSERTED
INTO THE REAR MONOCOLUMN COVER (#6).
Step 12 (Model 9100 Only)
Place the FRONT MONOCOLUMN COVER (#5) on the opposite side of the BACK MONOCOLUMN
COVER (#6) to cover the PIVOT SHAFT (G) and CONSOLE SUPPORT ASSEMBLY MOUNTING
SCREWS. Use four PHILLIPS PAN HEAD SCREWS (#3) to secure the MONOCOLUMN COVERS
together. Tighten the screws securely.
Step 13 (Model 9500HR Only)
Place the FRONT MONOCOLUMN COVER (#5) on the opposite side of the BACK MONOCOLUMN
COVER (#6) to cover the PIVOT SHAFT (G) and CONSOLE SUPPORT ASSEMBLY MOUNTING
SCREWS. Interlock the top tabs and use two PHILLIPS PAN HEAD SCREWS (#3) to secure the bottoms
of MONOCOLUMN COVERS together. Tighten the screws securely.
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS PAN HEAD SCREWS (#3).
13
14
5
H
F
Model 9500HR Shown
RECEIVER (#16). Slide the FOAM
G
16
15
13
5
H
Model 9100 Shown
Step 14 (Model 9500HR Only)
Locate one FRONT ROCKER COVER
(#13) and one BACK ROCKER COVER
(#14). Position the FRONT ROCKER
COVER over the user side of the left end
of the PIVOT SHAFT (F) (as shown)
making sure that it interlocks with the
MONOCOLUMN COVERS (#5 & #6).
Place the BACK ROCKER COVER over
the opposite side of the left end of the
PIVOT SHAFT in the same manner.
6
3
Secure the covers using three PHILLIPS
14
PAN HEAD SCREWS (#3). Repeat the
procedure reversing front and back for the
user right end of the pivot shaft.
3
G
16
F
15
6
3
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

91009500hr

Table of Contents