Life Fitness 8500 Service Manual page 47

Life Fitness Model 8500, 9100, and 9500HR Cross-Trainers
How To... Replace The Rear Covers
Tools required: Phillips magnetic screwdriver #2, Allen wrench set, 3/8" Socket set, and Standard wrench set
1. Remove the OUTER LINK COVER
by removing six(6) mounting
screws from each OUTER LINK
COVER.
2. Remove the ANTI-LIFT BRACKET
by removing two(2) mounting bolts
from each bracket.
3. Remove the clevis cover from each
pedal lever.
4. Remove the PEDAL LEVER by
removing the mounting bolt and nut
at each ROCKER ARM joint and
the hex bolt fom each ARM
EXTENSION.
5. Remove the PLUG from the LEFT
and RIGHT COVERS.
6. Remove the REAR COVER by removing
three(3) screws from the LEFT REAR
COVER then seven(7) screws from the
RIGHT REAR COVER.
7. Install rear covers in reverse order. Make
sure that each pedal lever roller guide is
centered over the roller. If not, lossen the
pedal lever assembly mounting bolt and
recenter the pedal lever so that it is
centered on the roller, then retighten the
YES NO
Correct Position Incorrect Position
of the Roller of the Roller
END VIEW OF
PEDAL LEVER
Rear Cover RH
Rear Cover LH
Pedal Lever
Assembly
Pedal Lever
Roller Guide
mounting bolt.
Crankarm
Shaft
Roller
Rocker Arms
Bolt
Plug
Anti-Lift
Bracket
Anti-Lift Bolts(2)
Torque
Arm Extension
30-35 FT. LBS.
Hex Bolt
Left
Right
Rear
Rear
Cover
Cover
Pedal Lever Nuts(2)
Torque
30-35 FT. LBS.
Bolt
Clevis
Covers
Pedal Lever RH
Cover Screws(6)
Torque
6-10 IN. LBS.
Outer Link
Cover RH
Plug
5