Life fitnes exercise bike assembly instructions (8 pages)
Summary of Contents for Life Fitness 9000HR
Page 2
Life Fitness and welcome to the world of and the Life Fitness 9000HR / 8500 treadmills. The following Parts Identification Listing and the step by step assembly procedures have been assembled to make the set-up of this treadmill as quick and easy as possible.
Page 3
If any parts are missing, contact Life Fitness Customer Support Services at the number listed on the back page of this assembly instruction booklet.
Page 5
LEFT and RIGHT UPRIGHTS (#1 & #2). The bend in the HANDLEBAR should face upward and tilt slightly forward. (Model 9000HR Only) Feed the WIRE HARNESS (B) leading from the right end of the HANDLEBAR into the access hole located on the inside of the USER RIGHT UPRIGHT (#2).
Page 6
(Model 9000HR Only) With the left side of the DISPLAY CONSOLE (#4) supported, carefully route the HEART RATE WIRE HARNESS (B) through the right side access hole of the DISPLAY CONSOLE. 10. (Model 9000HR Only) While pulling the USER RIGHT UPRIGHT (#2) slightly outward, carefully lower the DISPLAY CONSOLE (#4) onto the USER RIGHT UPRIGHT.
Page 7
21. Remove the tape securing the WAX TRAY (H) to the FRAME (A). Locate the WAX BAG (J). Position the HOSE CLAMP (K) over the WAX BAG HOSE (L) approximately three inches from the end of the WAX BAG HOSE. Engage the HOSE CLAMP. 22.
Before attempting to operate your Treadmill, it is imperative that you familiarize yourself with the contents of the Operation Manual. If your Life Fitness treadmill does not respond as described in the OPERATION MANUAL contact the nearest Life Fitness Service Center as listed in the OPERATION MANUAL.