Seat Locking Mechanism; Seat Assembly And Extrusion - Life Fitness Lifecycle 9500HR Series Service Manual

Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes
How To... REPLACE THE SEAT ASSEMBLY and EXTRUSION
Tools Required: 1/2 inch wrench, Standard screwdriver, and 5/32 inch Hex key wrench
1. See "How To...Replace Shrouds" in this section.
2. Remove the SEAT STOP in front of the seat support
by removing two screws from the top and front of the
seat assembly.
3. From under the EXTRUSION, disconnect the FLAT
FLEX CABLE 4-Pin Connector from the Main Cable,
unhook the FLAT FLEX CABLE from the clip, remove
two torx screws holding the retainer bracket for the
FLAT FLEX CABLE, and remove the grommet.
4. Disengage the LOCKING MECHANISM and carefully
back the SEAT ASSEMBLY off the EXTRUSION
while guiding the flat flex cable out from the seat
extrusion.
5. If necessary to replace the EXTRUSION, remove the
FLAT FLEX CABLE in the EXTRUSION, then
remove four mounting bolts located under the ends
of the EXTRUSION. Replace EXTRUSION and
torque four MOUNTING BOLTS 200-220 IN. LBS.
6. Install the new SEAT ASSEMBLY in the reverse
order and adjust SEAT ROLLERS. "See "How
To...Adjust Seat Roller Adjustment" in this section.
12
Mounting Bolts
(4 places)
Torque 200-220 IN.LBS.
Flat Flex Cable
Seat Locking
Mechanism
Extrusion
Top Screw
Front Screw
Seat Stop