Life Fitness Lifecycle 9500HR Series Service Manual page 49

Lifecycle 9500HR / 9100 Series Recumbent Exercise Bikes
How To...REPLACE THE FREEWHEEL/PULLEY ASSEMBLY (Continued)
6. Remove the RETAINER BOLT and
RETAINER from the end of the SHAFT.
7. Remove the left E-RING from the left
side of the PULLEY first, then remove
the right E-RING.
8. From the belt side, tap out the SHAFT
from the unit.
9. Pull the FREEWHEEL/PULLEY
ASSEMBLY forward and out of the
10. Slide the FREEWHEEL off the SHAFT
noting location of washers.
11. Install the new alternator in the reverse order. Make sure
that the ALTERNATOR BELT is properly aligned to the
LARGE PULLEY as shown otherwise damage to the belt
can occur.
12. Locate the alternator at the marked area on the alternator
bracket. Alternator belt tension should be from 60-70 lbs.
and the POWER GRIP BELT from 35-55 lbs.
6
bike.
E-Ring
Washer
Washer
Washer
Freewheel
Pulley
Alternator Belt
Large Pulley Alternator Pulley
Pulley Shaft
Retainer Bolt
Retainer
E-Ring