Computer Input; Input Source Selection - Sanyo PLC-XE45 Owner's Manual

Computer Input

Input Source Selection

Direct Operation
Select either Computer 1 or Computer 2 by pressing the
COMPUTER button on the remote control.
Before using COMPUTER button, select the correct input
source through Menu operation as described below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
frame pointer to the Input Menu icon.
2
Use the Point
ed
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button.
✔Note:
•Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.44).
•Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only the RGB signal.
•When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.45)
buttons to move the red
7 8
buttons to move the red arrow
Remote Control
COMPUTER button
COMPUTER button
*See Notes at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
Computer 1
Computer 2*
25