Figure 5. Opening and Closing the System
1.
slots
2.
tabs
3.
system cover
4.
cover release latch
Closing The System
1.
Ensure that all internal cables are connected and placed out of the way and that no tools or extra parts are left
inside the system.
2.
Align the tabs on the system cover with the corresponding slots on the system chassis.
3.
Lower the system cover onto the chassis until it clicks into place.
4.
Place the system upright on a flat, stable surface.
5.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Bezel
Removing The Bezel
1.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
2.
Lay the system on its side, on a flat and stable surface.
3.
Open the system.
4.
Lift the retention clips located at the edge of the bezel.
5.
Rotate the bezel away from the system to release the tabs on the bottom of the bezel.
28