Table of Contents
Advertisement
Installation
!
ATTENTION
Look into Application Guide Chart (enclosed) to determine which
emulation to program your unit into.
Match year, make, and model of your car and cross reference it
with MD, CD, or SAT emulation in EMULATION column.
IMPORTANT
We strongly recommend that you install the unit in an easily accessible location, so you can later upgrade
the unit or re-program it in case of incorrect programming.
Installation
@
Gain access to the back of your vehicle's Head Unit.
@
Find the same port as our Y-Harness (see "Connecting SoundLinQ3 to head unit")
@
Disconnect the existing connector and plug in our Y-Harness connector into this port, then plug female end of Audio
Harness to plug into your factory connector . Audio harness female connector is not used in some vehicles, in
this case isolate unused plug to prevent accidental shortage to vehicle body.
@
Plug the other end of Audio cable into designated port on this unit.
@
Connect SiriusXM Satellite Radio Tuner interface cable as shown in the picture. (see "Connecting the units")
@
Setup proper Emulation Mode for the unit (see "Emulation Mode Selection")
@
Turn the car on and check SoundLinQ3 functionality (especially Text capability) before the final assembly.
@
Please mount this unit in an easily accessible location for upgrading and re-programming purposes.
@
Secure the Head Unit in its original position.
Emulation Mode Selection (SAT emulation)
SAT Emulation Mode programming steps:
@
Properly install this unit.
@
Put "Left" programming switch in "DOWN" position.
@
Put ignition switch into the "ACC" position.
@
Wait for long beep followed by a few short beeps. This may take up to one minute.
@
Return programming switches into their default position (both switches "UP"). Wait up to 30 seconds until
confirmation beep.
@
Put ignition switch into the "OFF" position. Wait at least 10 seconds.
@
Put ignition switch into "ACC" or "ON" position.
@
Check SoundLinQ3 for functionality, especially TEXT capabilities.
1 2
ON
Ignition into
"ACC" or "ON"
Left switch
position
"DOWN"
1 2
ON
Both switches
Confirmation beep
"UP"
(Red LED blinks)
up to 30 sec
Confirmation beep
(Red LED blinks)
6
Ignition into
up to 10 sec
"OFF" position
Advertisement
Table of Contents
