Vais Technology SoundLinQ3 SL3sat Owner's Manual page 12

Audio interface controller with built-in siriusxm satellite radio interface

Hide thumbs Also See for SoundLinQ3 SL3sat:

Table of Contents

Satellite Radio controls

Tuner Radio ID

Satellite Radio Input Settings

You can adjust the input sound level of your satellite receiver. The sound level adjustment allows you to balance the

volume control with other sources connected to your head unit (such as CD player, FM radio, etc), and eliminate possible

distortions caused by high input levels.

Activate / Deactivate SETTINGS MODE

Go to SAT 3

Tune to channel 255

Press [Type Scan] 8 times to hear long beep (MUST be done within 1-2 seconds).

Using AM or AM/SAT button reselect sources to cycles to SAT 3

Satellite Sound Level Adjustment

Activate SETTINGS MODE

To adjust the sound level, first you must select a source that is not connected to the SoundLinQ3 unit, such as CD

player or FM radio. Set the volume to a comfortable level while listening to this source.

Change the source to SAT1 or SAT2 and select a satellite channel to listen to.

Change the source to SAT3.

Press and hold the button labeled SAT Lev Adj or number 5 on the Radio with its own LCD. You will hear a short

beep, and should then hear sound coming from the satellite receiver source.

Now you will adjust the sound level to match the volume of the source you selected in step 1. To adjust the sound

level, press either the TYPE < or TYPE > button.

Once the sound level matches the volume of your source from step 1, press the SAT Lev Adj (or number 5 on the

Radio with its own LCD) again to store the desired sound level in memory.

Deactivate SETTINGS MODE

Preset #5

Select Channel 255

Tuner "RADIO ID"

Satellite Radio Input Settings

SAT Radio Emulation

Satellite Radio Satellite Sound Level Adjustment

Table of Contents