Table of Contents
Advertisement
Satellite Radio controls
Display Settings
About Display Settings
SoundLinQ3 supports 8 types of Display Modes. Display Mode can ONLY be set up for the Satellite Radio source.
It is critical to setup, the correct Display Mode for the following reasons:
!
For Channel information to be displayed correctly.
!
For Text information to be displayed.
Display mode 1
- Minutes and Seconds used to display the selected channel number.
Minutes display hundreds, seconds display 00-99. DISC number and TRACK number are "invisible"
NOTE: This mode is preferred with CD changer emulation for Radio receivers with their own LCD.
Display mode 2
- Same as Display mode 1, except that DISC and TRACK number always display "1".
NOTE: Some Radio receivers refuse to display minutes and seconds if DISC or TRACK number are "invisible". Please use this
mode if your Radio receiver displays only "CD1" on the LCD.
Display mode 3
- In this mode TRACK number is used to display hundreds, Minutes are used to display tens, Seconds are
used to display single digits. DISC number is "invisible".
NOTE: This mode is most common for the radio integrated into the Navigation System.
Display mode 4
- In this mode TRACK number used to display hundreds, Minutes are used to display tens, Seconds are
used to display single digits. DISC number is always "1".
Display mode 5
- Alternate variation of Display mode 1.
Display mode 6
- In this mode TRACK number is either 10, 11 or 12 where "0" from 10, "1" from 11 and "2" from 12 are used
to display hundreds, Minutes are used to display tens, Seconds are used to display single digits. DISC number is always "12".
NOTE: This mode is most common for the radio integrated into the Navigation System which does not display Song Tilte in MD
changer emulation mode (Alternative for Display Mode 3, allows Song Title to be displayed for channels less than 100) .
Display mode 7
- In this mode TRACK number is either 10, 1 or 2 where "0" from 10, "1" and "2" are used to display
hundreds, Minutes are used to display tens and single digits. DISC number is always "12".
Display mode 8
- In this mode TRACK number is either 10,11 or 12 where "0" from 10, "1" from 11 and "2" from 12 are used
to display hundreds, Minutes are used to display tens, Seconds are used to display single digits. DISC number is always "12".
NOTE: Alternative to Display Mode 7.
NOTE: Use Display mode 8 in MD changer emulation mode. In this mode TRACK number is used to display the channel
number.
Changing Display Mode
@
Enter into "Satellite Radio Input Settings" Mode ( See "Satellite Radio Input Settings" for details).
Press [SCROLL UP] to switch between Display Modes.
@
@
Check channel 23, 81, 92, and 123, to confirm correct Display Mode selection.
@
Make sure both Disc Title and Track Title information is displayed correctly.
@
Exit "Satellite Radio Input Settings" Mode ( See "Satellite Radio Input Settings" for details).
CD/MD Changer Emulation
16
Advertisement
Table of Contents
