TC Electronic G-Force User Manual page 48

THE BLOCKS
The sizes: Box, Tiny, Grand & Huge are patterns emulating
extreme room sizes.
Reverb level
Adjusts the combined Room level and the Decay level, and
should be seen as a master level.
The Room level and the Decay can individually adjusted to
another relation in the Room and Decay section of the
algorithm. Range +/-50.
High color
Sets the treble color of the decay. When Color in the Room
section of the algorithm is set to Auto, it also controls the
treble factor of the initial room reflections.
Wool - Warm - Real - Clear - Bright - Crisp - Glass
High factor
Emphasizes or reduces the character set by the High color.
Range +/-25.
Low color
Sets the Bass color of the Decay.
Thick - Fat - Round - Natural - Light - Tight - Thin - No
bass.
Low factor
Emphasizes or reduces the character set by the Low color.
Range +/-25.
Room parameters
Adjusts the level of the initial room reflections, which is
master controlled by the Reverb level.
With this control you can emphasize or reduce the initial
room reflection's influence on the Reverb sound.
Range +/-50.
Color
Sets the tonal color of the initial reflections.
When set to Auto it is linked to High color
Auto - Wool - Warm - Real - Clear - Bright - Crisp - Glass.
Color factor
Emphasizes or reduces the character set by Color.
Range +/-50.
Predelay
Allows adjustment of the predelay (the time until the first
reflection appears) which is automatically set when choosing
the Room size. Range +/-50.
Decay level
Adjusts the level of the decay, which is master controlled by
the reverb level.
With this control you can emphasize or reduce the decay
tail's influence on the Reverb sound. Range +/-50.
46
Diffuse
Allows fine tuning of the density of the decay tails. Is set
automatically when choosing the desired Decay time. Makes
it possible to reduce flutter in the decay to an absolute
minimum. Range +/-25.
Decay start
Allows adjustment of the decay start (the time where the
Decay tail of the Reverb starts), which is set automatically
when choosing the Room size. Range +/-50.
Mix
This parameter sets the mix relation between the dry (direct)
and the wet signal. If you are using G-Force as an insert
effect this means that your direct signal goes through the
G-Force.
In Level
Controls the input level of the block.
Out Level
Controls the output level of the Reverb block.
Mute mode
See Mute mode in the introduction of this chapter.
Simple Reverb
The Simple Reverb is based on the same algorithm as the
Advanced, but the number of parameters are reduced to 5.
This makes it possible for you to set up the Reverb easily
and quickly
Type
Sets the type of the Reverb, meaning the size and
relationship between Predelay, Early reflections and Decay
automatically. (See Advanced Reverb for further
explanation).
Types: Room, Club, Hall, Church, Cathedral, Grand Hall,
Fast Decay, Slow Decay, Plate, Spring.
Decay time
Sets the length of the reverb decay from
0.01 - 20.0 seconds
Predelay
Allows adjustment of the predelay (the time until the first
reflection appears) which is automatically set when choosing
Type. Range +/-50.
Reverb level
Adjusts the combined Room level and the Decay level, and
should be seen as a master level.
The Room level and the Decay can be individually adjusted
to another relation in the Room and Decay section of the