TC Electronic G-Force User Manual page 15

HOW TO
board.
Your board is now be able to change ROM presets on the G-
Force.
How to change User presets using my MIDI board
If you want to change User presets in the G-Force via your board
this is what you should do:
- Enter the I/O Setup, MIDI display again.
- Scroll down to "Mapping mode" using the
Parameter wheel.
- Select "Into User bank" using the Value wheel.
Your board should now be able to change the User presets (given
that you made some) of the G-Force.
How to use some of the extra functions of my board
with the G-Force
A lot of boards on the market have the possibility of performing
MIDI on/off functions, MIDI bypass etc. The G-Force has a list
of board defaults that makes it possible to setup these boards
really fast. These are the boards in the list:
ART X-15 Ultrafoot
Digital Music Corp. Ground Control
Rocktron All Access
Roland FC-200
Custom Audio Electronics RS-10
If you own one of these boards here is what to do to set it up:
- Enter the I/O Setup, Control display.
- Scroll down to "Model" using the Parameter wheel.
- Select your board and press Enter to load the settings.
The G-Force is now setup to respond to the default settings of the
current board.
If your board is not in the list, here is what to do to setup some of
extra functions anyway:
- Enter the I/O Setup, Control display.
- Scroll down to the function you want to
control.
- Press Enter to activate the Learn function.
- Press the switch or pedal you want to use for the
current function.
You can perform this Learn function on all the parameters in the
Control display.
How to Recall a single block from
an existing preset
The G-Force have a possibility of Recalling a single block from
one preset into another. Try to Recall ROM preset # 23, called
"Stereo Touchwah". Now we will Recall the Filter block from
ROM preset # 12, called "Mono Farout Phaser".
- Press Recall.
- Dial the Parameter wheel to place the cursor on "Select".
- Dial the Value wheel until the matrix cursor is placed
on "FIL".
- Move the cursor back to "Preset" using the Parameter
wheel.
- Select preset 12 and press Enter to load the Filter
block into the current Routing.
The Filter block of preset 12 is now loaded into preset 23. This
partial Recall function can of course Recall blocks from ROM,
User and Card presets.
15