Maintenance - Porter-Cable PCB375SS Instruction Manual

WARNING
!
for your own safety, turn the switch off and remove
the plug from the power source outlet before
maintaining or lubricating your scroll saw.
GENERAL MAINTENANCE
WARNING
!
frequently blow out dust and grit that accumulates
in the motor housing using compressed air.
ALWAYS use safety glasses. Everyday eyeglasses
are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALWAYS WEAR CERTIFIED
SAfETY EQUIPMENT:
● ANSI Z87. eye protection (CAN/CSA Z94.3),
● ANSI S12.6 (S3.19) hearing protection,
● NIOSH/OSHA/MSHA respiratory protection.
An occasional coat of paste wax on the work table will
allow the wood being cut to glide smoothly across the
work surface.
WARNING
!
To avoid shock or fire hazard, if the power lead is
worn or cut in any way, replace it immediately.

MAINTENANCE

LUBRICATION
Ball bearings in the scroll saw are packed with grease at
the factory and require no further lubrication.
Use only mild soap and a damp cloth to clean the tool.
Never let any liquid get inside the tool; never immerse
any part of the tool into a liquid.
IMPORTANT: To assure product SAfETY and
RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be
performed by authorized service centers or other
qualified service organizations, always using identical
replacement parts.