Table of Contents
Advertisement
895736 - 08-31-00.qxd
WATER PUMP
The flow rate dial (A) Fig. 22B, should be set on the maximum setting.
RIP GUIDE
The rip guide is used to make precision cuts. Position the rip guide on the
cutting tray scale, to the amount of tile to be cut off. Hold the tile against the
rip guide and the cutting tray and proceed to cut the tile as discussed in the
section "OPERATING TILE SAW."
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts
should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic
parts. They could possibly dissolve or otherwise damage the material.
The cutting tray can be detached by pulling the locking pin (A) Fig. 23 out, so
that the tray can slide off the rail, for cleaning purposes. Change water in
water tray daily. Do not leave water in water tray overnight.
WARNING: DO NOT CUT TILE WITHOUT USING THE TILE
CUTTING TRAY.
CAUTION: Wear safety glasses while using compressed air.
2/14/02
3:55 PM
Page 12
A
Fig. 22B
MAINTENANCE
A
Fig. 23
12
12
Advertisement
Table of Contents
