Usb Board - HP 650 Maintenance And Service Manual

USB board

Description
USB board (includes cable)
Before removing the USB board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Memory module/wireless module compartment cover (see
b. Keyboard (see
c. Hard drive (see
d. Top cover (see
Remove the USB board:
1. Release the ZIF connector to which the USB board cable is connected, and then disconnect
the USB board cable (1) from the system board.
2. Remove the Phillips PM2.5×6.0 screw (2) that secures the USB board to the base enclosure.
Battery on page 36), and then remove the following components:
Keyboard on page 40)
Hard drive on page 46)
Top cover on page 50)
Spare part number
686269-001
Memory module on page
Component replacement procedures
37)
61