Temperature Sensor - ATTACK DPX15 Instructions For Use Manual

Oxygene probe (Lambda sonda)
Probe 1: Probe -
Probe 2: Probe +
Probe 3: Probe warming
Probe 4: Probe warming

Temperature sensor

Air flapV1 – V2, circuiting pump, suction fan
Terminal 3: Connection
Terminal 4: Connection 24V ~
Terminal 5: Regulation signal secondary
Terminal 6: Regulation signal primary Y+(0/2-10V)
Terminal 1: Flue gas sensor F1 Pt100
bayonet flange!
Terminal 2: Flue gas sensor F1 Pt100
Terminal 3: Boiler sensor F2 Pt100
Terminal 4: Boiler sensor F2 Pt100
Terminal 5:
Terminal 6:
Values of resistance:
┴
Y+(0/2-10V)
4-conductor silicone-covered flexicord
with conductor´s crossection of 0,75mm2
white = warming 12V
black= + signal of probe
grey = - signal of probe
Mount the flue gas sensor into the flue gas connection by
Do not extend connection conductor´s of sensors!!!
Boiler sensor and sensor of safety thermostat have to be
treated with warmwater paste, put into gasket and tighten by
holding spring!
Polarity is irrelevant
For connection of circuiting pump and
suction fan, use 3-conductor flexicord
with conductor´s cross section of
0,75mm2!
C: SHADING CONDENSATOR
Terminal 12: L: Circuiting pump
Terminal 13: N: Circuiting pump
Terminal 14: PE: Circuiting pump
Terminal 15: L: Suction fan
Terminal 16: N: Suction fan
Terminal 17: L: Free
Terminal 18: PE: Suction fan
45
~
the