Mode Settings; Table 5.7 Default Mode Settings (By Change Definition Command) - Fujitsu MAX3147NC Maintenance Manual

5.3.3

Mode settings

In addition to the previously described settings using setting terminals, the HDD is provided with several
mode settings. The mode settings are enabled by specifying the CHANGE DEFINITION command.
Table 5.7 lists the mode settings and their settings at factory shipment.
Refer to Subsection 3.1.4 "CHANGE DEFINITION (40)" of the SCSI Logical Interface
Specifications for details of the CHANGE DEFINITION command.
Table 5.7
SCSI level
SYNCHRONOUS DATA TRANSFER REQUEST message
sending
UNIT ATTENTION report mode
Reselection retry count
WIDE DATA TRANSFER REQUEST message sending
Reselection time-out delay
Spindle motor start delay time
5-10
Default mode settings (by CHANGE DEFINITION command)
Mode setting Contents
SCSI-3
Not sent from HDD
Reported
Not restricted
Not sent from HDD
250 ms
0 sec (NP)
12 sec × SCSI ID (NC)
C141-E229