C-3. Setting Up The Printer - Fujitsu FP-410 User Manual

C-3. Setting up the Printer

(1) Turn off the printer power switch, put the paper in place, and turn
on the printer power switch while holding down the FEED switch
on the control panel. Press the FEED switch for a short time.
When "Setup" is printed, press the FEED switch for about two
seconds to enter setup mode. The following data is printed:
SETTING
SAVE&END
DEFAULT SET
SETUP PRINT
SETTING
SELECTION ITEM
ITEM SELECTION: FEED SW IS PUSHED SHORT
ITEM SELECTION: FEED SW IS PUSHED LONG
SETUP MODE
(2) Pressing the FEED switch for about two seconds when "SETTING
" is printed puts the printer in setup mode and the setup group
items are printed.
(3) Select and determine the setup group items, setup items, and
detail setup items sequentially as shown below.
55