Using A New Accessory; Pairing A New Speed Sensor With Training Computer; Pairing A New Cadence Sensor With Training Computer; Pairing A New Gps Sensor With Training Computer - Polar Electro RCX5 User Manual
Hide thumbs
Also See for RCX5:
- User manual (59 pages) ,
- Getting started manual (29 pages) ,
- Manual (28 pages)
Table of Contents
Advertisement
ENGLISH
11. USING A NEW ACCESSORY
Before taking a new accessory into use, it has to be introduced to the training computer. This is called
pairing and takes only a few seconds. Pairing ensures that your training computer receives signals from
your accessory only, and enables disturbance-free training in a group.
Pairing a New Speed Sensor With Training Computer
Make sure the speed sensor has been correctly installed.
1.
Go to
>
Menu
Settings
and press OK.
new
2.
Press OK to start the test drive
3.
Press OK and
Searching for new speed sensor
the speed sensor signal. Rotate the wheel a few times to activate the sensor. The flashing red light in the
sensor indicates that the sensor is activated.
4.
Once the new speed sensor is identified,
5.
If the search is not successful,
,
further.
Try again? YES / NO
6.
Select
to start the search again.
YES
7.
Select
to cancel the searching.
NO
8.
To return to time mode, press and hold the BACK button.
For more information, on installing the speed sensor refer to the user manual of the speed sensor or for video
tutorial at http://www.polar.com/en/support/video_tutorials .
Pairing a New Cadence Sensor With Training Computer
Make sure the cadence sensor has been correctly installed.
1.
Go to
>
Menu
Settings
and press OK.
new
2.
Press OK to start the test drive
3.
Press OK and
Searching new cadence sensor
the cadence sensor signal. Rotate the wheel a few times to activate the sensor. The flashing red light in
the sensor indicates that the sensor is activated.
4.
Once the new cadence sensor is identified,
5.
If the search is not successful,
,
further.
Try again? YES / NO
6.
Select
YES
to start the search again.
7.
Select
to cancel the searching.
NO
8.
To return to time mode, press and hold the BACK button.
For more information on installing the cadence sensor refer to the user manual of the cadence sensor or to the
video tutorial at http://www.polar.com/en/support/video_tutorials .
Pairing a New GPS Sensor With Training Computer
Make sure the GPS sensor has been correctly attached, in an upright position and that your are wearing
the GPS sensor on the same arm as you are wearing your training computer. Also make sure you have
turned the GPS sensor on. For more information on how to set up the GPS sensor refer to the user manual
of the GPS sensor.
1.
Go to
>
Menu
Settings
42
Using a New Accessory
>
>
Sport profiles
Cycling (Bike 1)
is displayed.
Speed sensor found
Speed sensor not found
is displayed.
>
>
Sport profiles
Cycling Bike 1
is displayed.
is displayed. The training computer starts searching for
Cadence sensor found
Cadence sensor not found
is displayed.
>
>
Sport profiles
Running
>
Bike 1 settings
is displayed. The training computer starts searching for
is displayed. Pairing is complete.
or
Other speed sensors interfering. Move
>
Bike 1 settings
is displayed. Pairing is complete.
or
Other cadence sensors interfering. Move
>
>
GPS sensor
Search new
>
>
Speed sensor
Search
>
>
Cadence sensor
Search
and press OK.
Advertisement
Table of Contents
