Installing USB Software
This installation procedure is for 7600 scales with the USB option installed.
This procedure installs the USB drivers onto the computer which is at-
tached to the 7600 scale.
• Plug USB cable into computer USB port.
• Plug other end of USB cable into NCI USB Scale.
• If this is the first time for installation, the computer will recognize the
USB device and prompt for a driver for the 'Weigh-Tronix USB Serial
Adapter'.
• Press NEXT and follow instructions on the screen.
• Insert the W-T install CD and select CD-DRIVE for driver location.
• Select NEXT. The driver (KLSIWDM.INF) should be found and
installed on your computer.
• The W-T USB will now be set as a virtual communications port as
COM5 (Win9x/ME) or COM3 (Win2000). You can verify this by
selecting: SETTINGS-CONTROL PANEL-SYSTEM-DEVICE MAN-
AGER-PORTS.
• Enumeration is now complete and the W-T Scale display should
countdown and show weight.
Notes:
• If the W-T USB Scale has already been installed, the computer will
automatically recognize the device and no prompts will be shown.
• Up to five USB devices can be connected to a computer drawing no
more than 100ma each for a maximum of 500ma before a USB
repeater is required. The W-T USB 7600 series scale draws approxi-
mately 150ma and is therefore defined as two USB devices. The W-T
USB 3600 series scale with backlite option draws approximately
220ma and is defined as three USB devices.
• To uninstall the W-T USB Scale, insert the W-T Install CD and select
'WT-SCRUB'. The W-T USB Scale will be uninstalled.
• During the enumeration procedure, The W-T USB device draws less
than the required 100ma.
• Cable required for the W-T USB Scale is a Type A-B cable of up to 5
meters in length.
• USB data transmission is 12mbs.
38
Model 7600 Family PWC User's Manual