Table of Contents
Advertisement
34 www.aeg.com
13.4 The anti-tilt protection
13.5 Electrical installation
The manufacturer is not responsi-
ble if you do not follow the safety
precautions from the chapter
"Safety information".
This appliance is supplied without a
main plug or a main cable.
Applicable cable types: H07 RN-F, H05
RN-F, H05 RRF, H05 VV-F, H05 V2V2-F
(T90), H05 BB-F.
13.6 Covering terminal board
The recommended cross-section area is
six square millimetres (6 mm²).
B
50 mm
77 mm
A
WARNING!
You must install the anti-tilt pro-
tection (A+B). If you do not install
it, the appliance can tilt.
Before you install the anti-tilt
protection, adjust the appliance
to the correct height.
The anti-tilt protection has two compo-
nents (A+B). You can find the first com-
ponent (B) on the rear wall of the appli-
ance. It is on the right or left side of this
wall. (See the first illustration).
You must install the second component
(A) on the wall. Make sure that the wall is
made of a solid material. If not, you need
to make the wall sufficiently strong to
hold the weight. Make sure that the sur-
face behind the appliance is smooth.
Make the hole, in which you install the
component on the wall, approximately
77 mm from the top of the appliance.
Make sure that the component is on the
correct height. Use a screw to install it.
(See the second illustration).
Make sure that the anti-tilt protection
goes into the hole on the rear wall of the
appliance. After you push the appliance,
the anti-tilt protection must to go into
the hole for a minimum of 20 mm.
The space between the bench cup-
boards cannot be wider than the appli-
ance. If this occurs, adjust the space on
the two sides of the appliance. Put the
appliance in the center of the space.
When you refit the mains terminal cover,
make sure that the lower tabs are loca-
ted inside the bottom edge of the aper-
ture, before you fix the two screws into
the top edge of the mains terminal cov-
er.
Hide quick links:
Advertisement
Table of Contents
