Ec Declaration Of Conformity - Klein + Hummel O 300 Operating Manual

Klein + Hummel
Controller multicore cable (CMK 5)
A cable used to connect a Pro C 28 to the O 300 D (pictured below).
Metal grille (GO 300)
A metal grille can be attached to the front of the loudspeaker to protect the drivers. It simply clips into the
grooves on the long sides of the cabinet and adds 22 mm (7/8") to the depth and 3 mm (1/8") to the height of
the cabinet. It is damped to avoid rattles and has been designed for acoustic transparency (black version pictured
below). The grille is available in black and silver.
Flight case (FO 300)
As the original packing is primarily designed to get the loudspeaker from the factory to the end user, it is highly
recommended that a flight case is used if the loudspeaker is regularly moved between locations. One O 300 (D)
can be packed in the flight case.
5 – Multicore cable GO 300 – Metal Grille
CMK

EC Declaration of Conformity

This equipment is in compliance with the essential requirements and other relevant provisions of Directives
89/336/EC and 73/23/EC. The declaration is available on the internet site at www.klein-hummel.com. Before
putting the device into operation, please observe any respective country-specific regulations.
For loudspeakers fitted with digital inputs: Compliance to FCC Rules
This device complies with part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to
the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This class B digital apparatus complies with the Canadian ICES-003
Changes or modifications to this equipment not expressly approved by Klein + Hummel may void the FCC
authorization to operate this equipment.
O 300 (D) Operating Manual 16