€ Loudspeaker output jacks labeled with the IEC 417/5036 1. Safety Instructions emblem (Fig. A, right) may be carrying dangerously high It is absolutely essential that you read these safety voltages. If your unit has this emblem, ensure that any instructions carefully before connecting and using this connections to be made between these jacks and the K+H product.
Page 3
€ Always check before connecting the power cable to the Do not block or cover any heat sink, fan, or vent. mains socket that the power switch on the unit itself is set € Do not place the product where it will be in the path of to off ("O").
2.2 Operating LED on the front side indicates the correct operation. conditions The K+H model M 50 active control monitor is intended for 2.5 Volume control use over a range of ambient temperatures from +10° C to The volume control is located on the front panel. The maximum +40°...
On the bottom there is a 3/8" threaded bushing for mounting the M 50 on a standard microphone tripod. The LH 11 table Warning! mount bracket can be fixed to the two M6 threaded holes in...
(freight prepaid) to our distributor or directly to: KLEIN + HUMMEL GmbH Customer service Zeppelinstrasse 12 73760 Ostfildern / Germany K+H warrants, that the product is free from any defects in both material and manufacturing and that it meets the specifications.
Page 7
Specifications M 50 Free-field frequency response 120 Hz - 15 kHz ± 5 dB Power consumption Self generated noise @ 10 cm < 20 dB (A) Idle mains operation 2 VA Total harmonic distortion Idle battery operation 90 mA above 350 Hz <...
Need help?
Do you have a question about the M 50 and is the answer not in the manual?
Questions and answers