Safety Instructions Safety Instructions Safety Instructions Safety Instructions Safety Instructions It is absolutely essential that you read these safety instructions carefully before connecting and using this K+H product. Your safety depends on it. Furthermore, failure to follow these instructions voids the warranty. To ensure safe operation for years to come, keep these instructions in a safe place for future reference.
Figure 1 Front view T T T T T able of Contents: able of Contents: able of Contents: able of Contents: able of Contents: Safety Instructions..........2 1.7.3 Level ATT(ENUATOR)......6 Table of Contents..........3 1.7.4 INPUT SELECTOR Switch....6 1.7.5 EQ (Room Compensation)....6 1.
1. Installation and Operation 1. Installation and Operation 1. Installation and Operation to set the speaker on a standard 35-mm 1. Installation and Operation 1. Installation and Operation (1-3/8”) tripod. It is absolutely essential that you read It is absolutely essential that you read 1.1 It is absolutely essential that you read It is absolutely essential that you read It is absolutely essential that you read...
1.7.2.2 Source 2x AES/EBU 1.7.2.2 Source 2x AES/EBU 1.7.2.2 Source 2x AES/EBU 1.7.2.2 Source 2x AES/EBU 1.7.2.2 Source 2x AES/EBU Position A = Analog mode (XLR input) Position R = Digital mode right channel Position L = Digital mode left channel Position M = Digital mode mono (summed from both left and right channels) Simultaneous operation from one analog and...
1.8.1 CONTROLLER SELECT Switch 1.8.1 CONTROLLER SELECT Switch 1.8.1 CONTROLLER SELECT Switch 1.8.1 CONTROLLER SELECT Switch 1.8.1 CONTROLLER SELECT Switch This switch is used to deactivate the internal controller. By way of the jack labeled POWER - AMP DIRECT INPUT you can feed in signals intended for the three internal power amplifiers.
with a vacuum cleaner once it has been set in wear and tear. Take care when handling the place. The housing should be cleaned of dust enamel - coated cabinet not to damage the finish. from time to time in like manner. If you plan on To clean the cabinet, use a soft cloth with a mild taking your monitors from studio to studio, the cleaning agent only.
Page 9
for the tweeter. Thus came to be the dispersion Using the new material LRIM (L L L L L ow R R R R R esonance pattern we mentioned earlier which is narrower I I I I I ntegral M M M M M olding) allowed us to seamlessly vertically and broader horizontally, as is clearly integrate a waveguide into the baffle that is ideal evident in the test plots presented in Figures 4...
Since the enclosure is sealed, the increase in minimal, resulting in particularly tight, precise group delay at low frequencies (Figure 8) is quite bass response. Figure 9 Cumulative spectral decay (waterfall) The spectral decay plot of the loudspeaker unwanted overtones and standing waves. reveals excellent decay and an absence of 3.
4. T 4. T 4. Technical Specifications echnical Specifications echnical Specifications echnical Specifications O 300 D O 300 D O 300 D 4. T 4. T echnical Specifications O 300 D O 300 D Maximum SPL Maximum SPL Maximum SPL Maximum SPL Maximum SPL in half-space, 3% THD at 1 m distance...
Page 12
Indicators Operational status K+H logo constantly illuminated Limit/Clip K+H logo blinking Mains Power fixed voltage, verify on device label Power consumption Idle 18 VA Full power 240 VA Physical characteristics Physical characteristics Physical characteristics Physical characteristics Physical characteristics Connectors Mains Three terminal Euro connector Analog / digital inputs XLR connector, 3-pin...