Troubleshooting - Honeywell Horizon 7600 Installation And User Manual

Troubleshooting

The following guide is for reference purposes only. Contact a customer service
representative to preserve the limited warranty terms.
SYMPTOMS
All Interfaces
No LEDs, beep
or motor spin.
No LEDs, beep.
3 beeps on
power up.
Continuous
razz tone on
power up.
Razz tone and
amber LED flash
at power up.
Razz tone and
both LEDs flash
at power up.
Multiple scans
upon
presentation of
code.
The unit powers
up, but does
not beep.
32
POSSIBLE CAUSE(S)
No power is being
supplied to the
scanner.
No power is being
supplied to the
scanner from host.
Non-volatile RAM
failure.
RAM or ROM failure.
VLD failure.
Scanner motor failure.
Same symbol timeout
set too short.
Beeper disabled
No volume is selected
No tone is selected.
SOLUTION
Check transformer, outlet and
power strip. Make sure the
cable is plugged into the
scanner.
Some host systems cannot
supply enough current to power
7600 series scanner. Use the
power supply included with the
scanner.
Contact a customer service
representative, if the unit will not
hold the programmed
configuration.
Contact a customer service
representative, if the unit will not
function.
Contact a customer service
representative.
Contact a customer service
representative.
Adjust same symbol timeout for
a longer time.
Enable beeper
Select volume
Select tone.