Honeywell Horizon 7600 Installation And User Manual page 37

SYMPTOMS
The unit powers
up, but does
not scan and/or
beep.
The unit scans
a bar code, but
locks up after
the first scan
(red LED stays
on).
The unit scans,
but the data
transmitted to
the host is
incorrect.
Scanner beeps
at some bar
codes and NOT
for others of the
same bar code
symbology.
POSSIBLE CAUSE(S)
Scanning a particular
symbology that is not
enabled.
The scanner has been
programmed for a
character length lock,
or a minimum length
and bar code being
scanned does not
satisfy the
programmed criteria.
The scanner is
configured to support
some form of host
handshaking but is not
receiving the signal.
The scanner's data
format does not match
the host system
requirements.
The print quality of the
bar code is suspect.
Also check character
length lock.
The aspect ratio of the
bar code is out of
tolerance.
SOLUTION
UPC/EAN, Code 39, interleaved
2 of 5, Code 93, Code 128 and
Codabar are enabled by default.
Verify that the type of bar code
being read has been selected.
Verify that the bar code that is
being scanned falls into the
criteria.
(Typical of Non-UPC/EAN
codes. The scanner defaults to
a minimum of 4 character bar
code.)
If the scanner is setup to support
ACK/NAK, RTS/CTS,
XON/XOFF or D/E, verify that
the host cable and host are
supporting the handshaking
properly.
Verify that the scanner's data
format matches that required by
the host. Make sure that the
scanner is connected to the
proper host port.
Check print mode. The type of
printer could be the problem.
Change print settings. For
example change to econo mode
or high speed.
33