System Network; Wan/Lan1 - Thecus N0503 User Manual

NOTE

System Network

Use the System Network menu to make network configuration settings as well as
service support settings.

WAN/LAN1

WAN/LAN1 Configuration
From the System Network menu, choose WAN/LAN1, and the WAN/LAN1
Configuration screen appears. This screen displays the network parameters of the
WAN/LAN1 connection. You may change any of these items and press Apply to
confirm your settings. See a description of each item in the following table:
WAN/LAN1 Configuration
Item
Host name
Domain name
WINS Server
MAC Address
Jumbo Frame Support
IP Sharing Mode
Link Aggregation
Set IP Address by:
Static / Dynamic
IP
Netmask
Gateway
DNS Server
The system must be rebooted before Thecus IP storage can function
normally after file system check complete.
Description
Host name that identifies the Thecus IP storage on the network.
Specifies the domain name of Thecus IP storage.
To set a server name for NetBIOS computer.
MAC address of the network interface.
Enable or disable Jumbo Frame Support of the WAN/LAN1 interface on your
Thecus IP storage.
When enabled, PCs connected to the LAN2 port will be able to access the
WAN/LAN1.
Specifies whether WAN/LAN1 and LAN2 ports will be aggregated and act as
one port. There are 6 modes can be choose from:
Load Balance/Fail-over/Balance-XOR/802.3ad/Balance-TLB/Balance-ALB
You can choose a static IP or Dynamic IP, and input your network
configuration
IP address of the WAN/LAN1 interface.
Network mask, which is generally: 255.255.255.0
Default Gateway IP address.
Domain Name Service (DNS) server IP address.
53