Thecus N0503 User Manual page 62

Disks Information
Item
Disk No.
Capacity
Model
Firmware
Status
Bad Block scan
Total Capacity
Disk Power
Management
NOTE
S.M.A.R.T. Information
On the Disks Information screen, the status of each disk will be displayed in the
Status column. Clicking on an OK or Warning link will display the S.M.A.R.T
Information window for that particular disk.
You may also perform disk SMART test, simply to click "Test" to start with. The
result is only for reference and system will not take any action from its result.
S.M.A.R.T. Information
Item
Tray Number
Model
Power ON Hours
Temperature Celsius
Reallocated Sector
Description
Indicates disk location.
Shows the SATA hard disk capacity.
Displays the SATA hard disk model name.
Shows the SATA hard disk firmware version.
Indicates the status of the disk. Can read OK, Warning, or
Failed.
Yes to start scan Bad Block.
Shows the total SATA hard disk capacity.
The administrator can set the disk to power down after a period of
inactivity.
When the Status shows Warning, it usually means there are bad sectors on the
hard disk. It is shown only as a precaution and you should consider changing the
drives.
Description
Tray the hard disk is installed in.
Model name of the installed hard disk.
Count of hours in power-on state. The raw value of this attribute
shows total count of hours (or minutes, or seconds, depending on
manufacturer) in power-on state.
The current temperature of the hard disk in degrees Celsius
Count of reallocated sectors. When the hard drive finds a
62