Connections To Other Equipment - Hitachi 42PD380TA-P1 User Manual

Connections to other equipment

The exact arrangement you use to interconnect various video and audio components to the Plasma
Display is dependent on the model and features of each component. Check the Owner's Manual provided
with each component for the location of video and audio inputs and outputs.
The connection diagrams below are offered as suggestions. You may need to modify them to accommo-
date your particular assortment of components. The diagrams are intended to show component video and
audio interconnections only.
Note: Select a appropriate external input mode
To connect the Plasma Display to a VCR
Rear lower of the Plasma Display
To connect the Plasma Display to a VCR with an S-Video cord
If you connect a VCR with a S-VIDEO cord to the S-VIDEO IN jack on the rear of the Plasma Display, you
must also connect the audio cords to the AUDIO IN jacks on the rear of the Plasma Display. The S-VIDEO
cord only carries the video signal. The audio signal is separate.
Rear lower of the Plasma Display
To AUDIO
IN 1 (or 2)
NOTE:
When the S-video cord and the video cord are connected to each jack at the same time, the S-video cord
takes precedence over the video cord.
3U81641A [E] P13-17
42PD380TA-P1
.
18
To AV IN 1 (or 2)
Audio/Video cord (not supplied)
To Audio/Video OUT
To S-VIDEO IN 1 (or 2)
S-Video cord (not supplied)
Audio cord (not supplied)
HITACHI
13
To S-Video OUT
To Audio OUT
9/16/05, 7:26 PM
13