Table of Contents
Advertisement
Remote Control
Install the batteries
Use batteries type UM-4 (AAA-Size).
Do not use the storage batteries. The remote control does not work properly with weak voltage from the storage
batteries. Replace the exhausted batteries with new batteries. Never charge batteries. Batteries may explode by
the charge.
Note:
An exhausted empty batteries may leak, namely corrosive electrolyte will leak out. The remote control may
damage by it. Therefore remove the exhausted batteries early.
1
Open the battery compart-
ment.
Distance of Remote Control Operation
directly at the remote sensor.
The remote control handset will not work properly in the following cases:
If bright sunlight directly beams onto the unit front.
If the batteries have not been installed according
to their polarities.
3U81641A [E] P09-12
42PD380TA-P1
2
Install the batteries as shown
below.
Point the remote control
Transmitter window
HITACHI
11
3
Close the battery
compartment.
Maximum distance approx. 5m
30
30
If an obstacle is placed between the unit and the
handset.
If the batteries are weak.
9/16/05, 7:26 PM
11
Advertisement
Table of Contents
