Atx Power Installation; Micropci Daughter Card Installation - IBASE Technology IB800 User Manual

Full-size socket 478 pentium 4 intel 845 cpu card

Table of Contents

INSTALLATIONS

ATX Power Installation

Power is provided to the IB800 CPU card with the J2 and J12 ATX power

connectors. Please note that the J12 external ATX power connector

should be connected to the backplane for IB800 to function. J12 is

located below the IDE connector. Please refer to the figure below.

The IB800 CPU card is integrated with a MicroPCI socket that uses

SO-DIMM 144-pin connectors. These sockets can accommodate the

optional MicroPCI daughter cards.

To insert the MicroPCI daughter cards, position it at 30 to the PCB and

gently push it into the MicroPCI connector (See Figure 1 below). The

card will not fit when inserted at an angle of 45 or 15 . Once inserted,

slowly press the card towards the PCB until it locks on both sides to the

clips of the connector. Screw the card to the PCB to secure the

installation. To remove the MicroPCI card, pull the 'clips' sideways as

shown in Figure 2 below.

Figure 1.

Figure 2.

IB800 User' s Manual

Table of Contents

Table of Contents