Grecom PSR-310 Owner's Manual page 90

LED Mode
LED Color
Latch LED
Backlight
Alarm
Fav
EXPERT BELOW
Modulation
Atten
Delay
90
Solid or Flash
0-7
On or Off
On, Off or Flash
None, Chirp, Hi-Lo,
Alert, Ring, 2-Chirp,
Fast Hi-Lo, DTMF#
Yes or No
AM, FM, NFM, Auto
On or Off
On or Off
Controls whether the ALERT LED
flashes or remains on solid when
the ALERT LED is used.
Sets LED color to 0-7 as defined in
the GLOB menu. By default, 0=LED
Off, 1=Red, 2=Yellow, 3=Green,
4=Cyan, 5=Blue, 6=Magenta,
7=White.
Normally the ALERT LED is active
only while the object is receiving a
transmission. When Latch is on, the
ALERT LED will remain lit after the
transmission is complete, unless
overridden by a subsequent object
that is also using the ALERT LED.
Controls whether the backlight
should be on, off or flashing while
the object is active.
Sets the Audible Alarm for the LMIT
object. When an Audible Alarm is
selected, the selected alarm will
play anytime the scanner stops for
activity on the LMIT object while
scanning.
When Yes, the LMIT object is a
member of the Favorites Scan List.
Modulation setting for the LMIT
search. In most cases Auto will
work fine. Use AM to override and
force AM modulation, FM to force
FM modulation, NFM to force nar-
row FM modulation.
When on, applies 20 dB of attenua-
tion to all hits received on the LMIT
search. Useful in areas where inter-
ference from nearby strong signals
is present.
Controls whether a Delay is used
to wait for reply traffic after a trans-
mission is received during the LMIT
search.