Clone Mode - Kenwood TK-8102H Service Manual

TK-8102H
3-2. Connection Procedure
1. Connect the TK-8102H to the personal computer with the
interface cable.
2. When the Power is switched on, user mode can be en-
tered immediately. When the PC sends a command, the
radio enters PC mode.
When data is transmitted from transceiver, the red LED
blink.
When data is received by the transceiver, the green LED
blink.
In the PC mode, 4CH LEDs, [MON] LED and [ ] LED are
turned on.
Notes :
• The data stored in the personal computer must match
model type when it is written into the EEPROM.
• Attach the interface cable, then change the TK-8102H to
PC mode.
3-3. KPG-46 Description
(PC programming interface cable : Option)
The KPG-46 is required to interface the TK-8102H to the
computer. It has a circuit in its D-subconnector (25-pin) case
that converts the RS-232C logic level to the TTL level.
The KPG-46 connects the modular microphone jack of
the TK-8102H to the computers RS-232C serial port.
KPG-70D
3-4. Programming Software Description
The KPG-70D programming disk is supplied in 3-1/2" disk
format. The software on this disk allows a user to program
TK-8102H radio via a programming interface cable (KPG-46).
3-5. Programming With IBM PC
If data is transferred to the transceiver from an IBM PC
with the KPG-70D, the destination data (basic radio informa-
tion) for each set can be modified.
8
REALIGNMENT
IBM-PC
KPG-46
TK-8102H
Fig. 1

4. Clone Mode

Programming data can be transferred from one radio to
another by connecting them via their modular microphone
jacks. The operation is as follows (the transmit radio is the
master and the receive radio is the slave).
Note :
Clone mode should enabled.
1. Turn the master TK-8102H power ON with the [1] key
held down. The TK-8102H [ ] LED is turned on.
2. Power on the slave TK-8102H.
3. Connect the cloning cable (No. E30-3382-05) to the
modular microphone jacks on the master and slave.
4. Press the [ ] key on the master TK-8102H transceiver.
The data of the master is sent to the slave. While the
master is sending data, [TX] LED blinked. While the slave
is receiving the data, 4 LEDs, [MON] LED, [ ] LED are
turned on and [BUSY] LED blinked. When cloning of data
is completed, the master [TX] LED turned off, and the
slave automatically operates in the User mode. The slave
can then be operated by the same program as the mas-
ter.
5. The other slave can be continuously cloned. Carry out
the operation in step 2 to 4.
4-1. Adding the data password.
If the data password is set in the optional feature menu,
you must enter the password (Master transceiver) to acti-
vate a clone mode.
you can use 1, 2, 3, and 4 to configure the password. The
maximum length of the password is 10 digits.
1. [1]+Power ON.
2. [1]~[4] LED, and MON LED are turned ON.
3. Enter the password using [1]~[4] keys.
4. Press [MON] key.
5. If the password matches, the transceiver enters a clone
mode. Otherwise, transceiver beeps and returns to the
password input mode.
Clone cable
(E30-3382-05)
Fig. 2