Adjustment - Kenwood TK-8102H Service Manual

Test Equipment Required for Alignment
Test Equipment
1. Standard Signal Generator
(SSG)
2. Power Meter
3. Deviation Meter
4. Digital Volt Meter
(DVM)
5. Oscilloscope
6. High Sensitivity
Frequency Counter
7. Ammeter
8. AF Volt Meter
(AF VTVM)
9. Audio Generator (AG)
10. Distortion Meter
11. 4 Dummy Load
12. Regulated Power Supply
13. Spectrum Analyzer
14. Tracking Generator
Tuning cable (E30-3383-05)
Adapter cable (E30-3383-05) is required for
injecting an audio if PC tuning is used.
See "PC Mode" section for the connection.
Lead wire +
Shield wire –
MIC

ADJUSTMENT

Frequency Range 400 to 520MHz
Modulation Frequency modulation and external modulation
Output –127dBm/0.1 V to greater than –7dBm/100mV
Input Impedance 50
Operation Frequency 400 to 520MHz or more
Measurement Capability Vicinity of 100W
Frequency Range 400 to 520MHz
Measuring Range 1 to 20V DC
Accuracy High input impedance for minimum circuit loading
DC through 30MHz
Frequency Range 10Hz to 1000MHz
Frequency Stability 0.2ppm or less
20A
Frequency Range 50Hz to 10kHz
Voltage Range 1mV to 3V
Frequency Range 20Hz to 20kHz or more
Output 0 to 1V
Capability 3% or less at 1kHz
Input Level 50mV to 10Vrms
Approx. 4 , 10W or more
13.6V, approx. 20A (adjustable from 9 to 17V)
Useful if ammeter requipped
Center frequency 50KHz to 600MHz
Output Voltage 100mV or more
Test cable for microphone input (E30-3360-08)
MIC connector
(Front view)
8
1 : BLC
2 : PSB
3 : E
4 : PTT
5 : ME
6 : MIC
7 : HOOK
8 : CM
Major Specifications
1
TK-8102H
27