Installation Instructions - Master Spas legacy whirlpool Owner's Manual

INSTALLATION INSTRUCTIONS

1.) Put spa in final position that allows for access to equipment and spa components.
5.) It may be necessary to bleed air from the pump(s) on your spa if, after start up, your spa pumps
do not operate.
Due to the nature of water flow and hydro-therapy pumps, please be advised that air locking of
pumps may occur. Master Spas has taken measures to reduce the possibility of this, but it still may
occur, especially after refilling a spa. This is not a service covered under warranty.
To relieve an airlock situation, loosen the union (see picture) on the discharge of the pump (see
arrow on picture of pump below). Water should leak out. Tighten the union and test the pump for
proper jet flow. If needed repeat process.
Airlock
6.) Adjust water chemistry according to the instructions provided in the
"Water quality Maintenance Section" (page 20).
7.) Your spa water will heat approximately 4° - 7° per hour, for all 240V spas.
This varies depending on the size of the spa. Step into the soothing waters
of your new Master Spa!
RelaX and enjoY.
DO NOT DIVE.
2.) Remove front side panel (This is the side where the main topside
control panel is located) so electrical can be hooked up to the spa
system pack. Panels are removed by unscrewing the screws in the
corner sections and side panels (using #2 square bit). Using a Phillips
screwdriver may result in stripping of the screw.
3.) Fill spa at least 1" above the filters. We recommend filling the spa
through the filter area.
4.) Turn the power on to the spa. Spa will go through its priming
mode. This lasts approximately 5 minutes.
Pump Union
16