Configuring The Ip Address When Vlan Status Is Enabled - GE MDS iNET 900 Reference Manual

05-2806A01, Rev. J
Figure 2-16. Network Interface Configuration Menu
• —Defines whether the radio handles Ethernet
VLAN Status
frames in "extended" 802.1Q mode or in "normal" mode in the
Ethernet port. Ethernet frames intended for the radio, but with a
VLAN ID not configured in the radio are discarded.
[
enabled, disabled; disabled
NOTE: A change made to the above parameter will result in the
Commit Changes option appearing on screen. This will modify
the appearance of the screen depending on the option selected.
•
Ethernet Port Mode
port or as an access port. Auto mode defines the port as an
access port in an AP, or a trunk port in a Remote radio. [
Trunk, Access; Auto
•
Management VLAN ID
to the radio itself, other than the terminal server process. This
VLAN ID is used for filtering and for tagging purposes.
[ ]
1-4094; 2
• —Defines the VLAN ID assigned to traffic directed
Data VLAN ID
to and from the Ethernet port and the terminal server process in
the radio. This VLAN ID is used for filtering and for tagging
purposes. [
1-4094; 3
•
Config Management IP
address associated with the Management VLAN ID.
• —Calls up a menu to configure the IP address asso-
Config data IP
ciated with the Data VLAN ID.
•
Default Route IF
gateway in the radio. [

Configuring the IP Address when VLAN Status is Enabled

The radios require a local IP address to support remote management and
serial device (terminal server) services. When the radio is configured for
VLAN operation the IP address can only be set as a static IP address.
iNET Series Reference Manual
Invisible place holder
]
—Defines if the Ethernet port acts as a trunk
]
—Defines the VLAN ID for traffic directed
]
—Calls up a menu to configure the IP
—Defines the VLAN that contains the default
MGMT, DATA; MGMT
Auto,
]
41