Ping Utility Menu; Reset To Factory Defaults; Password Reset - GE MDS iNET 900 Reference Manual

110
• —Incoming received signal strength on frequency
RSSI
entered in the frequency parameter on this screen (–dBm).
This RSSI measurement is updated more frequently than the
RSSI by Zone display of the Performance Information menu.
Note that for the MDS iNET, the RSSI is an average of the
RSSI samples. The RSSI value is reset every time the radio
returns to scanning mode.

2.9.7 Ping Utility Menu

Figure 2-70. Ping Utility Menu
• —Address to send a PING. [
IP Addr
• —Number of PING packets to be sent.
Count
• —Size of each PING data packet (bytes).
Packet Size
• —Send PING packets to address shown on screen.
Go
Screen will be replaced with detailed report of PING activity.
Press any key after viewing the results to return to this menu.

2.9.8 Reset to Factory Defaults

To reset all transceiver parameters back to the factory defaults,
including the password, you must enter a special code (authorization
key) provided by the factory in place of the user name at the time of
login.
This procedure is useful when several parameters have been modified,
and there is no track of changes. It causes the transceiver to return to a
known state.

Password Reset

As part of the reset action the transceiver's password is reverted to the
default value of
admin
parameters to return to the factory default settings, including zone skip-
ping (as applicable), baud rate settings, network name, security phrase,
etc.
iNET Series Reference Manual
. As a security measure, this event causes all radio
]
Any valid IP address
05-2806A01, Rev. J