GE MDS iNET 900 Reference Manual page 28

18
Table 1-4. Accessories (Continued)
Accessory Description
Ethernet RJ-45 Cable assembly used to connect an Ethernet
Straight-thru device to the transceiver. Both ends of the cable
Cable (CAT5) are wired identically.
(Cable length ≈ 3 ft./1M)
EIA-232 Shielded cable terminated with a DB-25 male
Shielded Data connector on one end, and a DB-9 female on the
Cable other end. Two lengths available (see part
numbers at right).
EIA-232 Shielded cable terminated with a DB-9 male
Shielded Data connector on one end, and a DB-9 female on the
Cable other end, 6 ft./1.8m long.
Fuse Small, board-mounted fuse used to protect
against over-current conditions.
Flat-Surface Brackets: 2˝ x 3˝ plates designed to be screwed
Mounting onto the bottom of the unit for surface-mounting
Brackets & the radio.
Screws
Screws: 6-32/1/4˝ with locking adhesive.
(Industry Standard MS 51957-26)
DIN Rail Bracket used to mount the transceiver to
Mounting standard 35 mm DIN rails commonly found in
Bracket equipment cabinets and panels.
COM2 Interface DB-25(F) to DB-9(M) shielded cable assembly
Adapter (6 ft./1.8 m) for connection of equipment or other
EIA-232 serial devices previously connected to
"legacy" units. (Consult factory for other lengths
and variations.)
MDS NETview PC-based network management system for
MS Software new-generation GE MDS transceivers. Allows
radio control and diagnostics in a hierarchal
map perspective.
Bandpass Filter Antenna system filter that helps eliminate
interference from nearby paging transmitters.
Ethernet Surge Surge suppressor for protection of Ethernet port
Suppressor against lightning.
iNET Series Reference Manual
Part No.
97-1870A20
97-3035L06
(6 ft./1.8m)
97-3035L15
(15 ft./4.6m)
97-1971A03
29-1784A03
82-1753-A01
70-2620-A01
03-4022A02
97-3035A06
03-3938A01
20-2822A02
29-4018A01
05-2806A01, Rev. J