Safety Warnings - Belling Built-in Electric Induction Users Manual & Installation Handbook

All linstallation, servicing and
maintenance work should be carried
out by a competent person who will
comply with current regulations. This
appliance must be earthed.
standards and Requirements.
When you have finished
cooking check that all controls
are in the off position.
Introduction
This oven can be installed on the runner
system provided or by placing on
the cabinet shelf when you have produced
a cut out as illustrated in the
installation instructions within this
handbook.

safety Warnings!

1) The glass ceramic located in the
base of the oven (cavity) can get hot
whilst cooking; even though the cook
zone itself does not generate heat. The
heat generated is conducted back
from the hot cooking pot or pan.
2) This induction oven complies with
the applicable EMc and EMF standards.
Therefore it should not interfere
with other electronic units. Persons fitted
with a pacemaker or any other
electrical implant should clarify with
their doctor or the producer of the
implant, whether their implant is ad-
equate
and fail-safe, the pacemaker
must be designed in compliance with
the appropriate regulations.
3) Its important that you use the cast
iron pot supplied or a good quality ferrous
based, flat bottomed cook pot or
pans. If a cook pot or pan creates a
large air gap over the middle of the
cooking zone , the accuracy of the
using the oven - inDuCtion
temperature sensing can be affected.
4)Warning:- Do not use the oven if the
glass is cracked, as electrical parts are
directly beneath. To avoid the possibility
of electric shock, turn off the electricity
supply to the hob at the socket
and arrange a service call.
5) Commercial simmering aids should
not be used as they create excessive
temperatures that can damage the sur-
face
and may cause a hazard.
Note - Take care not to catch the edge
of the glass base when placing the
cook pot in and out of the oven as this
could cause the glass to chip.
Note -
Take care not to slide the pot
across the glass base as this will
scratch the base of the oven.