Charging An Empty Battery - Husqvarna Auto Mower Operator's Manual

Charging an empty battery

These instructions apply when Auto Mower is new, or after a long period of storage.
If the Auto Mower has been used recently it does not need to be started in the charging station, see the chapter "Start and stop".
Place the Auto Mower in the charging
station for 60 minutes
The charging pins must be in contact with the
charging station contact plates. Set the Auto
Mower power switch to "STOP" for the battery to
be charged gently.
After 1 hour flip the power switch
to on
An audible beep indicates that the battery has
enough power to run the electronics.
Enter code ( code #)
*
A short beep is heard and LED 1 lights each
time a button on the keypad is pressed.
Code accepted
A short beep is heard and LED 1 lights on the
keypad. Lower the cover.
Auto Mower continues to charge
Auto Mower signals 2 beeps/10 seconds (LED 1
flashes) and starts as soon as the battery is fully
charged. Note the battery is not charged on
delivery. Charging an uncharged battery normally
takes 2–4 hours.
USE
Incorrect entry
A long beep is heard and LED 6 flashes. OR
Incorrect code
A long beep is heard and LED 6 flashes. The
keypad is now switched off. You must wait 2
minutes before making a new attempt.
Contact your dealer if you have lost your code.
13
English –