Table of Contents
Advertisement
SNMP
Chapter 6 Firmware Upgrade Procedure
Trango Broadband Wireless will from time to time release firmware upgrades for the Atlas series radios. The latest
released firmware can be downloaded from http://www.trangobroadband.com/support/downloads.htm.
Firmware releases consist of two files: Main image firmware and Web (HTTP interface) firmware.
You can update the firmware on your Atlas either over-the-air, or locally via the Ethernet port.
The upgrade package may include two type of files the Main Image and Web Image Firmware Files.
Atlas Main Image Firmware File < P4900m_main_1p0r3D06100301_Pupgrade>
Atlas Web Image Firmware File < P4900m_web_1p0D06041001_Pupgrade>
Before beginning the upgrade procedure, be certain that all of these files have been downloaded and extracted to an
easily accessible directory on your local hard drive.
UPGRADE PROCEDURE
1. Place the firmware files in an easily accessible directory path on your computer.
2. Telnet into your unit by clicking on the Start menu and RUN. Type telnet <ip address> to connect to the unit.
(figure 1&2) The figures use the default IP address, you must use the correct IP address for you Atlas unit.
Figure 1
3. At the login enter your password for Read/Write access. The default password is trango (figure3)
4. Enable the tftp daemon as shown below. (figure3)
#> tftpd on
5.
Once enabled the prompt should show
#>Success.
Trango Broadband Wireless — Atlas4900 User Manual Rev. 1.3
Figure 2
page
22
Advertisement
Table of Contents
Need help?
Do you have a question about the ATLAS4900 and is the answer not in the manual?
Questions and answers