Recheck The Installation - Magma PE6R4-I User Manual

M A G M A
Carefully position the expansion chassis so that the supplied expansion
cable will conveniently reach from the host computer to the connectors
on the back of the chassis. Connect end A of the cable to the chassis
and end B to the host card as follows:
Connect End A to
the chassis along with the power cord.
CAUTION
All cables attached to the expansion chassis must be securely
fastened. When you hear a "click," it is properly secured. If not
securely connected, the connectors may cause intermittent or lost
connections.
NOTE
If at all possible, plug all power cords from the expansion chassis
and your host computer into a shared power strip, preferably one
that has surge and noise suppression circuitry built into it.

Recheck the Installation

Check your installation before powering up the Magma expansion
chassis for the first time. Although the power supply has an over voltage
protection device built into it, it may not "trip" in time to fully protect a
device that has been improperly connected, or whose power cable has
been damaged.
6 Chapter 2 Hardware Installation
Connect End B to
the host card.