Chapter 2 - Installation & Connection; System Requirements; Installation & Uninstallation Of Configuration Utilty - Aztech HomePlug Turbo Easy Start

C hapter 2 – Installation & Connection
2.1

System Requirements

HomePlug Ethernet Adaptor is applicable with all TCP/IP operating systems with Ethernet port.
Drivers are not required for this adapter. But the supplied software and the network password
operates only with Windows operating systems.
Your computer must meet the below mentioned minimum requirements in order to use the
HomePlug Ethernet Adaptor Configuration Utility:
•
Windows Operating Systems:
•
Windows 98SE, Windows Me, Windows 2000 Windows XP, or Windows Vista
with Ethernet connection
•
Pentium III 300 MHz MMX-Compatible PC or greater
•
128MB hard disk space and memory
•
CD-ROM drive
Your computer or the device to which you want to connect the HomePlug
Ethernet Adaptor must have an Ethernet port, i.e. a network card or a network
adaptor.
2.2
Installation & Uninstallation of Configuration Utilty
Windows Operating Systems
Installation:
1. Connect the HomePlug Ethernet Adaptor to the computer or the device with the Network
cable.
2. Connect the HomePlug Ethernet Adaptor to the Power Outlet.
3. Install the Configuration Utility (PowerPacket). The Resource CD has auto run feature. If
the Resource CD auto run fails, please run the Setup.exe file in the CD.
4. Follow the on screen instructions to install the utility drivers.
Easy Start
Note...
Easy Start Page 6 of 20